Plastic Solar-Powered Flashing Road Marker
Our Solar-Powered Double-Sided Plastic Flashing Road Markers are innovative solar-powered road studs that can be used to indicate lane markings, road dividers, junctions, speed bumps, and pedestrian crossings. Easy to install and require no additional wiring or power source. They charge during the daytime and turn on automatically at night and off at sunrise. Paired with two high visibility reflectors, each marker has 2 ultra bright LED bulbs that flash to increase nighttime visibility. The robust ABS plastic frame, polycarbonate top cover, and tightly sealed battery compartment can withstand weathering from rain, snow, and harsh sunlight, and can withstand up to 15 tons of weight. Thickened smooth edges reduce the impact to vehicle wheels.
Features:
- Designed to be used on new pavement or as retrofits for existing traffic markers.
- Road stud includes 2 super bright amber LEDs.
- Visibility of approximately .12 miles / 633 feet.
- Reflectors on either side add to visibility, meets ASTM standard.
- LEDs automatically flash at night and turn off during the day.
- Flash rate of 95 times/minute.
- High-quality solar panel charges during the day.
- Up to 60 hours of lighting in flash mode after a full charge (40 hours in steady mode).
- Can be mounted vertically or flat on the ground.
- Can be installed on roads, pathways, fences, stairs, walls, docks, or trees.
- Resists compression of up to 15 tons of weight, allowing for use on most roads without fear of being crushed or damaged.
- Sealed design with water resistant rating IP68.
- Can be mounted with construction glue, 2 screws, or asphalt-binding epoxy (all not included).
Specifications:
| Visibility | .12 miles / 633 feet |
| Length/Width | 3.9” x 3.6” |
| Height | .75” |
| Weight | .28 lbs. |
| Materials | acrylic reflector, ABS plastic, PC top cover |
| LEDs | 2 yellow or white, 3mm |
| Solar Panel | 3V 50mA |
| Battery | Ni-Mh, 600mAh |
Installation:
- Clean the surface of the installation area.
- Use glue or screws to hold the road stud in place, ensuring lighted sides are facing toward oncoming traffic.
- Can be mounted with construction glue (not included), screws (not included) or asphalt-binding epoxy (Sikadur-42 epoxy grout recommended; not included).
LOGIN 
